Lavor DYNAMIC A4 Manual De Instrucciones página 28

Carefully read the "instruction manual" be-
☞
fore starting, using, performing unscheduled or
routine maintenance or any other work on the
machine.
•
Rigorously comply with all the instructions
provided in this manual and in those for the
batteries and battery chargers (with particular
attention to warnings and danger notices).
The manufacturer will not be held responsible
for injuries to persons or damage to property
due to non-compliance with the aforemen-
tioned instructions.
☞ Before using the machine, make sure that each
part is in the correct position.
•
The machine can only be used by personnel who
have received appropriate training, who have proven
their skills and who have been expressly assigned to
use it. To avoid unauthorised use, keep the machine
in a place that denies access to unauthorised person-
nel when not being used.
• Minors are prohibited from using the machine.
• Do not operate this machine for any other purpose
except for the use for which it was specifically de-
signed. Evaluate the type of building where it will be
utilised and rigorously comply with the current safety
regulations and conditions.
• Do not use the machine in places without ad-
equate lighting, in explosive environments, when
harmful dirt is present (dust, gas, etc.), on roads or
public passage ways and in outdoor environments
in general.
• The machine operating temperature range is +4°C
to + 35°C; when not being used, store the machine
in a dry and non-corrosive environment within a tem-
perature range of between + 10°C and + 50°C.
When using the machine under any condition the hu-
midity must range between 30% and 95%.
• Never use or vacuum liquids, gases, dry
dust, acids and solvents (e.g. paint thinners,
acetone, etc.), even if diluted, inflammables
or explosives (e.g. petrol, fuel oil, etc.); never
vacuum flaming or incandescent objects.
• Do not use the machine on slopes or ramps
steeper than 10%; for small slopes, do not use the
machine sideways, always handle it with caution and
never move backwards. When transporting the ma-
chine on steeper ramps or slopes, be very careful to
avoid tipping and/or uncontrolled accelerations. Use
only the lowest speed! The machine can be handled
on ramps and/or steps only with the brush head and
squeegee lifted off the ground.
• Never park the machine on a slope.
☞ The machine should never be left unattended with
the motors running; it can be left unattended only
after turning off the motors, ensuring that it won't
make any accidental movements and disconnecting
it from the electric power supply.
• Make sure there are no other persons, and chil-
dren in particular, in the area where the machine is
being used.
• Do not use the machine to transport persons/
things or to tow objects. Do not tow the machine.
☞ Do not use the machine as a support surface for
any weight for any reason.
Do not block the ventilation and heat dispersion
openings.
• Do not remove, modify or by-pass the safety de-
vices.
• Always use individual safety devices to ensure op-
erator safety: aprons or safety overalls, non-slip and
waterproof shoes, rubber gloves, goggles and ear-
phones, and masks to protect the respiratory tract.
Before starting to work, remove necklaces, watches,
ties and other objects that may cause serious inju-
ries.
• Do not insert hands between moving parts.
☞ Do not use detergents that differ from those re-
quired and follow the instructions indicated on the
relative safety sheets. Detergents should be stored
in a place that is inaccessible to children. In case of
contact with the eyes, rinse immediately with copi-
ous amounts of water and, if swallowed, immediately
consult a physician.
Make sure that the battery charger power sockets
are connected to an efficient earthing system and
that they are protected by magnetothermal and dif-
ferential circuit-breakers.
• If you are going to equip the machine with dry
(gel) batteries, be sure the battery power indicator
on the control panel, has been set properly. Check
this procedure with your dealer.
• Follow the battery manufacturer's instructions and
comply with legal provisions. The batteries should
always be clean and dry to avoid surface leakage cur-
rents. Protect the batteries against impurities, such
as metallic dust.
• Do not place tools on top of the batteries: they
may cause a short-circuit or an explosion.
• When using battery acid, rigorously respect the
relative safety instructions. In the presence of par-
ticularly strong magnetic fields, evaluate the possible
effect on electronic control devices.
Never spray water on the machine to clean it.
☞ Recovered fluids contain detergents, disinfectants,
water, as well as organic and inorganic material col-
lected during work operations: dispose of them in
accordance with current legal provisions.
• If the machine malfunctions and/or operates inef-
ficiently, turn it off immediately (disconnecting it from
the electric power supply or from the batteries) and
do not tamper with it.
Contact one of the manufacturer's technical service
centres.
• All maintenance or accessory replacement opera-
tions must be carried out in environments with ade-
quate lighting and only after having disconnected the
machine from the electric power supply by detaching
the battery connector.
☞ All work on the electrical system and all main-
tenance and repair operations (especially those not
28