Test Result And Assay End; Turning The Meter Off - iLine microsystems microINR Instrucciones De Uso

• After the beep, gently move the finger away and wait until
the INR results are displayed on the screen.
If you apply the sample and no sound is emitted, this means
that there is not enough sample volume. Remove the Chip and
repeat the test with a new Chip. Ensure that the size of the drop
is enough and the entry channel is not blocked when placing it.
Do not reapply sample or try to add more blood to the
channel.
Never perform the fingerstick before the start of the
countdown.
Do not touch the Chip's entry channel with the finger
while inserting the sample.
Keep the Meter away from direct sunlight during the test.
Do not shake or drop the Meter. If the Meter is dropped
or gets wet and the frequency of error messages
increases, contact your distributor.

Test Result and Assay End

• The measurement is performed and the Meter displays the
result in INR units or an error message.
Error messages are
displayed as a letter
"E" followed by a
number. If an error
message is shown, follow the steps in the
"Error Guide" section".
• Remove the Chip, holding it from both sides.
The used Chips, lancets and gloves might be source of
infection.
For healthcare professionals: dispose
the materials according to your
institution´s infection control policy
and the appropriate local regulations.
For self-testing patients: you can
dispose all the materials in your
garbage bin. Discard the used lancets
with care to prevent injuries.

Turning the Meter Off

There are two ways to turn the Meter off:
• The Meter turns off automatically after
3 minutes of inactivity.
• Press the left button (EXIT) to turn the
Meter off, holding it for 3 or 4 seconds.
The Meter cannot be turned off while
connected to the power supply.
10