DeWalt D25900K Manual Del Usuario página 26

E N G L I S H
Setting the electronic impact power control dial
(fig. A)
• Turn the dial (3) to the desired level.
The higher the number, the greater the impact
energy. With dial settings from «1» (low) to «7»
(full power) the tool is extremely versatile and
adaptable for many different applications.
The required setting is a matter of experience. E.g.:
- when chiselling soft, brittle materials or when
minimum break-out is required, set the dial to «1»
or «2» (low);
- when breaking harder materials, set the dial to
«7» (full power).
Fitting and adjusting the side handle (fig. D)
The side handle (4) can be mounted on the front of
the machine to suit both RH- and LH-users.
Always operate the machine with the
side handle properly mounted.
• Unscrew the side handle clamp knob (7).
• Slide the side handle assembly onto the machine
locating the steel ring (8) in the mounting area (X).
• Adjust the side handle (4) to the desired angle.
• Slide and rotate the side handle to the desired
position.
• Lock the side handle in place by tightening the
clamp knob (7).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply a pressure of approx. 20 - 30 kg
to the tool. Excessive force does not
speed up chiselling but decreases tool
performance and may shorten tool life.
Switching on and off (fig. A)
• Switching on: set the on/off switch (1) to position 1.
• Switching off: set the on/off switch (1) to position 0.
Demolition, chasing and channelling (fig. A)
• Select the appropriate chisel, and clean and
grease its shank.
26
• Insert the chisel and check whether it is properly
locked.
• Set the desired impact energy level.
• Fit and adjust the side handle (4) and make sure
it is firmly tightened.
• Hold the tool at both handles (2 & 4) and switch
on. The tool now runs in continuous operation.
• Always switch off the tool when work is finished
and before unplugging.
Various types of SDS-max
an option.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• This machine is not user-serviceable. Take the
tool to an authorised D
approximately 100 hours of use. If problems
occur before this time contact an authorised
D WALT repair agent.
E
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Accessory maintenance
Accessory maintenance at the right time guarantees
optimal results in application and a long and efficient
accessory life.
Unwanted tools and the environment
Take your tool to an authorized D
agent where it will be disposed of in an
environmentally safe way.
® chisels are available as
WALT repair agent after
E
WALT repair
E