Mellerware VORTEX Manual De Instrucciones página 6

3.4.5.3. Hold the filter by the edges and "TAP CLEAN"
on a hard, flat surface until the dust particles are
removed from between the pleats of the filter.
3.4.5.4. The HEPA type filter may also be washed with
lukewarm water by holding it under a running tap and
allowing the water to run on the dirty side. We recom-
mend washing it at least once a month depending on
how often you use it or when the suction appears to
reduce.
3.4.5.5. Always allow the filter to air dry for at least 24
hours before placing it back into the vacuum.
NB Ensure the filter is completely dry before placing
back into the vacuum.
3.4.5.6. Reinstall the filter into the dust cover and click
it back onto the dust bin.
Please Note that it is normal for the filter to discolor
over time, this will not affect the performance of the
filter.
3.4.6 Reinstalling the dust bin:
3.4.6.1. Ensure that the small intake air vent on the
dust bin is aligned with the opening on the main unit.
3.4.6.2. Slide the dust bin into place and push back
until you hear it lock into place.
CAUTION: The suction hole must be open and free of
any obstructions at all times. Otherwise, the motor will
overheat and could become damaged.
Warning: Always empty the dust bin container and
31100_IM.indd 6
clean the HEPA type filter after each use and during
prolonged usage.
Never over fill the dust bin container, remove dirt and
clean the HEPA type filter when dirt in dust bin is at or
just below the "MAX" level during prolonged usage or
risk motor damage.
If you wash the HEPA type filter, ensure that it is com-
pletely air dry before inserting back in the vacuum.
Please Note: The HEPA type filter is washable. It
should, however, be replaced when damaged. Replace-
ment filters are available at Creative Housewares.
Contact details are below.
3.5 Once you have finished using the appliance:
3.5.1. Allow appliance to cool down.
3.5.2. Unplug the appliance from the mains power
supply.
3.5.3. Clean the appliance as described in the cleaning
section.
4. Cleaning
4.1. Clean the dust bin: when the dust bin is almost
on max, it is time to empty the dust cylinder. Open the
front cover by unclipping the dust cylinder lock. Take
out the bin and empty it.
4.2. Cleaning the HEPA type filter: once the dust bin is
removed un-clip the top handle to remove the HEPA
type filter. Please do not wash. The HEPA type filter
must be shaken to remove dust particles. This should
be done at least once a month.
4.3. Cleaning the air outlet filter: this is situated at the
back of the vacuum. Un-clip the back cover to remove
the air outlet filter. This should be washed at least
every six months. Allow to dry in the sun at least 24hrs
before using again(Ensure that the air outer filter is
properly dry before use).
NB: Please ensure that the filters are clean before
use. This will prolong the life of the motor.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
06-Jul-17 11:28:32 AM