DeWalt DW871 Manual De Instrucciones página 23

• Support long workpieces using a piece
of wood (27) (fig. G). Do not clamp the
cut off end (28).
Quick travel feature (fig. C)
The clamp has a quick travel feature.
• To release the clamp, rotate the handle (17) one
or two turns counterclockwise and pull the lever
(19) in the direction of the arrow (15).
Setting the clamping position (fig. C)
The clamping position can be set to match the
cutting disc.
• Move the clamp lever (18) in the direction of the
arrow (15) to release the fence.
• Move the fence as required.
• Move the clamp lever (18) in the direction of the
arrow (16) to lock the fence.
If the clamp lever resistance is too light,
slightly tighten the two adjusting bolts on
the fence.
Adjusting the angle of cut (fig. D)
This D WALT chopsaw can be used for mitre cuts
E
up to 45°.
• Turn the clamp lever (18) counterclockwise to
release the fence.
• Set the fence (20) to the required angle.
The angle can be read on the scale (21). Use the
slot edge (22) as a reference.
• Tighten the clamp lever by turning it clockwise.
Adjusting the spark deflector (fig. E)
• Loosen the screw (23).
• Set the spark deflector (24) as appropriate.
• Tighten the screw (23).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Do not apply excessive pressure to
the tool.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
17
Prior to operation:
• Install the appropriate cutting disc. Do not use
excessively worn discs. The maximum rotation
speed of the tool must not exceed that of the
cutting disc.
• Make sure the disc rotates in the direction of the
arrows on the accessory and the tool.
• Secure the workpiece.
• Always set the spark deflector correctly.
Performing a cut (fig. A)
• Place the material to be cut against the fence (7)
and secure using the material clamp (6).
• Switch on the machine and pull down the control
handle (2) to cut the workpiece. Allow the motor
to reach full speed before cutting.
• Allow the disc to cut freely. Do not force.
• After completing the cut, switch off the machine
and return the arm to its upper rest position.
Switching ON and OFF (fig. A)
The ON/OFF-switch (1) of your chopsaw is mounted
in the control handle (2).
• To run the tool, press the ON/OFF-switch (1).
• Keep the ON/OFF switch depressed while pulling
down the control handle (2) to cut the workpiece.
• To stop the tool, release the switch. The tool will
automatically travel to its rest position.
Do not switch the tool ON or OFF when
under load.
Do not cut magnesium.
Consult your dealer for further information on the
appropriate accessories.
Transport (fig. H & I)
Your D WALT power tool is equipped with a lock-
E
down pin (29) which locks the tool in closed-down
position for carrying.
• Lower the guard (4) onto the cutting table (9) and
secure the Power Tool in this position by pushing
in the lock-down pin (29) (fig. H).
• Transport the power tool using the carrying
handle (3).
• To release the tool, pull out the lock-down pin (29)
(fig. I).
E N G L I S H
en - 5