Idiomas disponibles
Idiomas disponibles
Illustration 4
Right end
panel
Top edge
Illustration 5
Arrow
Right end panel
Illustration 6
Cam bolt
Shoulder
Cam bolts
242-7670B
SIDE 2 OF 4 (9/04)
LATERAL FILE BOOKCASE
Cam bolt
Back
Top edge
Cam connector
Back
Dowel
Top
4. Refer to Illustration 4. Attach right end panel to
back. Insert end panel cam bolts into holes in side
of back. Ensure top edge of back and end panel
are facing down.
5. Refer to Illustration 5. With arrows facing end
panel, install cam connectors (from hardware pack)
into holes along side of back. Use the Phillips
screwdriver to tighten cam connectors. Turn cam
connectors clockwise to tighten.
6. Refer to Illustration 6. Lay top, with holes up, on
cardboard or a carpeted surface.
Use the rubber mallet to install dowels (from hard-
ware pack) into the locations shown.
Place reveals over dowels. Position reveals so that
the outside edge of each reveal is flush with edge
of top.
Reveal
Use the Phillips screwdriver to install two cam bolts
(from hardware pack) through each reveal and into
desk top. Tighten cam bolts until cam bolt shoulder
is flush against surface of reveal.
Use the Phillips screwdriver to install a cam bolt
(from hardware pack) into hole along rear edge of
top. Tighten cam bolt until cam bolt shoulder is flush
against surface of top.
