Allmatic Hyper 400 Manual Del Usuario página 28

6.2 DETERMINE THE INSTALLATION MEASUREMENTS (OUTWARD OPENING)
Before fixing the supplied brackets it is necessary to determine the installation dimensions A and B.
Start by putting the gate in position of "OPEN DOOR".
Choose the sizes of A and B from Tables 7 and 8 of the previous paragraph, according to your installation and in order to obtain
the desired degree of opening "α". This grade shown in the table refers to the highest possible degree of openness with the
corresponding dimensions.
For the anchor of the piston it is necessary to use additional supports (not supplied) together with the fixing brackets supplied. These
supports shall be appropriate to the dimension of the door and the pillar.
TOP VIEW
W
B
ADDITIONAL SUPPORT
(NOT PROVIDED)
6.3 FASTEN THE REAR BRACKET TO THE COLUMN
Attach the rear bracket to the column in accordance with the agreed dimensions.
The orientation of the rear bracket is different between right and left door.
WARNING!
In determining the height from the ground to which the bracket is fixed on the pillar, take into account that the brackets
for anchoring the piston to the gate shall be fixed at the same level, and that the motor shall be installed at least
50mm away from the lower edge of the gate door.
Incorrect positioning of the mounting bracket or the use of inadequate installation dimensions could
result in one or more engine components breaking.
After properly fixing the bracket to the column, anchor the back of the gearmotor to the bracket using the supplied hardware as
shown in the figure.
12 - English
ATTENTION!
With respect to the type of installation descri-
bed in the previous paragraph, the measure-
ments of A and B are inverted in position (SEE
FIGURE).
The support drawn in the following figure, to which the rear bra-
cket is connected is only an example for explanatory purposes.
With this type of installation, the automations protrude and then
reduce the width of the passage.
A
EXTERNAL SIDE
OF THE PROPERTY
INTERNAL SIDE OF
THE PROPERTY
6-1624982 - rev.3 - 03/11/2021