Electrical Conection - HJM 830 Instrucciones De Uso

3. Do not operate the appliance if damaged. Remove the feet from
packing. Turn the heater upside-down on a rug or a soft surface in
order to prevent damaging the paint finish.
4. Put the feet into the correct position as shown in figures 1 and 2
5. Turn the heater to its upright position for operation.

ELECTRICAL CONECTION

Before plugging the radiator into the mains, check that the voltage of
your mains electricity supply corresponds to the value V indicated on
the appliance and that the socket and power line are appropriately
dimensioned.
CAUTION: Only operate the heater in normal upright position with
Feet attached to the bottom of the heater, any other position could
create a hazardous situation
TO OPERATE:
• Place the heater in an upright position on a flat, steady, stable, heat-
resistant surface. Make sure there is nothing flammable or heat
sensitive within 1 meter (40 inches). Operating the heater in any other
position could cause a hazard.
• Insert the plug into a suitable wall outlet on an A.C. power supply
having the same voltage as that show on it's rating label after turning
the thermostat knob counter-clockwise to the minimum position
• Turn the thermostat knob clockwise to maximum position. When the
temperature rises to with a comfortable level, slowly turn thermostat
counter-clockwise until the power indicator light just goes out. To
adjust the room temperature turn the thermostat clockwise to raise the
temperature, or counter-clockwise to lower it. Your unit will be
automatically set an on-and-off cycle to maintain the current room
temperature according to thermostat setting. (Note: It normally
requires approx. 15 minutes to reach the operating temperature.)
- 14 -