Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
• Improves ambient air quality
2
• Eliminates electrostatic charges
• Helps maintain good health and protects the skin
3
6
5
INSTALLATION OF ThE DEMINERALISATION FILTER
4
7
• Place the demineratlisation cartridge in the space located in the base of the unit as explained in
14
13
the diagram of figures 1 and 2.
• Replace the reservoir and wait a few minutes before starting the unit so that the water is
filtered.
INSTALLATION INSTRUCTIONS
• Place the unit in the room half an hour before turning it on, so that it may take the surrounding temperature.
• It is recommended to use the unit in a temperature located between 5°C and 40°C and with a relative humidity of less
than 50 % RH.
• Remove the reservoir from the unit; unscrew the plug by swivelling it counterclockwise.
• Fill the reservoir with clear water at 40°C maximum. Check that the silicone washer is in place, and then close the cover
by turning it clockwise.
• Make sure it is clean and waterproof then place the reservoir delicately on the base unit.
• With dry hands, plug in the unit.
• Press on the button
8
working. It will start to emit steam. After a few seconds, the humidity level is displayed
9
• When the reservoir is empty, the corresponding light
12
11
10
1
VAPOLUX FUNCTIONS
1
1
2
2
• Humidity level control
5
5
Press on the button
2
vary from 20% to 90%. After blinking for 5 seconds, the LCD screen shows the room's humidity level. When the value of
humidity reaches the preadjusted level, the unit stops emitting steam after a few minutes.
1
• Anion function
Press on the anion fan button
screen. If you press this button again, the anion fan function will be interrupted. The indicator will stop blinking.
14
13
12
11
10
2
• Steam emission intensity
1
It's possible to set the steam emitted by the device. To do so, press repeatedly on the button
remote control. The unit will go then from position 1 «Strong Constant Steam» (320-370ML/H) to position 2 «Medium
Constant Steam « (240-290ML/H) and finally to position 3 «Light Constant Steam» (120-180 ML/H).
• Timer function
2
The unit can work continuously for 20 hours. However, you can determine the use life of the unit. Press repeatedly on
the button
of the control panel or remote control to adjust the desired use (2 h, 4 h, 8 h or 12 h). As soon as the set
time is over, the unit turns off automatically.
Attention: ALTHOUGH THE UNIT IS FITTED WITH SAFETY MECHANISMS THAT CUT OFF TRANSDUCER
OPERATION, TURN THE UNIT OFF WHENEVER POSSIBLE.
12
11
10
1
2
on the control panel or remote control. The light turns on, which means that the unit is
5
1
4
3
6
or
of the control panel or remote control to choose the desired humidity level. This can
1
1
8
9
. The anion fan function is activated. The anion fan indicator will blink on the LCD
2
2
4
3
6
8
9
4
3
6
turns on and the unit turns off automatically.
2
1
2
5
1
2
5
1
2
of the control panel or
Vapolux
EN
1
2
5
Tabla de contenido
