Climate class
SN
N
ST
T
•
Stand your appliance in a dry place to avoid
moisture damage.
•
Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away from
heat sources such as stoves, fires or heaters.
Leveling of appliance
For sufficient leveling and air circulating in the
●
lower rear section of the appliance, the bottom
feet may need to be adjusted.
You can adjust them manually using a suitable
●
spanner.
To allow the doors to self-close, tilt the top
backwards by about 10mm.
Reversing the door
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied) to the
left side, if trequired.
Warning! When reversing the door, the appliance
must not be connected to the mains. Ensure that
the plug is removed from the mains socket.
Tools you will need
not provided
Thin-blade
8mm socket
screwdriver
wrench
Cross-shaped
Monkey wrench
screwdriver
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
≤10mm
Putty knife
8mm wrench
Left Hinge Cover
Note: If required you may lay the refrigerator on
its back in order to gain access to the base, you
should rest it on soft foam packaging or similar
material to avoid damaging the backboard of the
refrigerator. To reverse the door, the following
steps are generally recommended.
1. Stand the refrigerator upright. Open
the upper door to take out all door racks and
tank (to avoid damage) and then close the door.
2. Use a putty knife or thin-blade screwdriver to
prize the screw hole cover which is at the top left
corner of the refrigerator, and the upper hinge
cover which is at the top right corner of the
refrigerator.
Screw hole
cover
3. Unscrew the special flange self-tapping screws
which are used for fixing the right upper hinge
part by a 8mm socket driver or a spanner (please
support the upper door with your hand when
doing it) .
Upper hinge
cover (right)
9