Installation Instructions; First Use; Door Space Requirements; Leveling The Unit - Candy CNF 1726 FW Manual Del Usuario

If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will
1.
cause the compressor to run for long periods.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm at the
2.
rear and 30 cm at the top of the unit. This will allow cold air to circulate around the appliance
and improve the efficiency of the cooling process.
The appliance should be located on a smooth surface.
3.
Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts
4.
rusty. And do not spray water to the freezer, otherwise it will weaken the insulation and
causes current leakage.
Refer to "Cleaning and Care" section to prepare your appliance for use.
5.
Do not drape the refrigerator with any covering.
6.
The appliance is designed to operate at the limited range of ambient
7.
temperature, depending on climate zones. Do not use the appliance at the
temperature out of the limit. Climate class of your appliance is indicated on the
label with technical description inside the fridge compartment.
 extended temperate: 'this refrigerating appliance is intended to be used at ambient
temperatures ranging from 10 °C to 32 °C';
temperate: 'this refrigerating appliance is intended to be used at ambient temperatures

ranging from 16 °C to 32 °C';
subtropical: 'this refrigerating appliance is intended to be used at ambient temperatures

ranging from 16 °C to 38 °C';
 tropical: 'this refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 43 °C';

First use

Before initial start, keep the refrigerator still for two hours before connecting it to power
1.
supply.
Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3 hours, or for
2.
above 4 hours in summer when the ambient temperature is high.

Door Space Requirements

The unit's door must be able to open fully as shown.
W min. 1023 mm
D min. 989 m

Leveling the Unit

To do this adjust the two leveling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments
will not be covered properly.
Make sure that the foot touches the ground before use.
Look down from the top, clockwise and counterclockwise loosening,
tightening.

INSTALLATION INSTRUCTIONS

14