Bulteh 2000 EKOMILK Guia Del Usuario página 18

ERROR LIST
ERROR
MESSAGE
Motor damage. Contact your dealer to make the repairs. Meanwhile
MOTOR
you may use the Analyzer in MOTOR OFF mode. (see "MILK ANALYSIS
ERROR
WITHOUT SUCTION PUMP").
1. Air bubble in the measuring sensor.
Fill again the mug with the same milk sample and make a fresh start.
2. The suction system has some air leak.
EMPTY
Check the Plastic Plug position and fix it if it is necessary. If the Plastic
CAMERA
Plug stays loose in the Syringe, replace the Syringe.
If the problem still exists, test the analyzer in MOTOR OFF mode.
If no problem occurs in this mode, the Pump is out of order. Contact
ERROR 02
your dealer to make the repairs. Meanwhile you may use the Analyzer
in MOTOR OFF mode. (see "MILK ANALYSIS WITHOUT SUCTION
PUMP").
3. If the problem still exists, the measuring system is contaminated or
damaged. Contact your dealer to make the repairs.
1. The milk sample temperature is +above the spec. Fill again the mug
HOT
with milk sample with proper temperature and make a fresh start.
SAMPLE
2. If the problem still exists, the measuring system is contaminated or
damaged. Contact your dealer to make the repairs.
Incorrect Password.
WRONG
Reenter the password
PASSWORD
Attempt to enter a calibration value out of allowed limits. See
BRATION VALUES SAVING".
CAL OUT
If a calibration value out of allowed limits is really needed, the measur-
OF RANGE
ing system is out of order. Contact your dealer to make the repairs.
FW
The Main processor is damaged . Contact your dealer for repairs.
MISHMACH
ERROR 03
PROM is damaged or erased. Contact your dealer for repairs.
There is no communication between the main processor and PROM -
ERROR 07
PROM is burnt or not properly put in the socket. Contact your dealer to
make the repairs.
1. The power supply voltage is below spec. Use proper power supply
voltage value.
ERROR 09
2.The measuring system is out of order. Contact your dealer to make
the repairs.
PROM reading/writing problem. Switch off/on the analyzer and try again.
ERROR15
If the problem still exists, the PROM is damaged. Contact your dealer to
make the repairs.
18
PROBLEM & CAUSES & REMEDY
"CALI-