Bosch Ciso Manual Original página 43

OBJ_BUCH-894-001.book Page 43 Tuesday, November 25, 2008 2:22 PM
Battery Charging (see main figure)
Do not use other battery chargers. The supplied bat-
tery charger is designed for the Lithium-Ion battery in
your machine.
Observe correct mains voltage: The voltage of the power
source must agree with the voltage specified on the
nameplate of the unit. Equipment marked with 230 V can
also be connected to 220 V or 240 V.
The Electronic Cell Protection (ECP) protects the lithium
ion battery against deep discharging. When the battery is
run down or discharged, the machine is shut off by means
of a protective circuit: The blade no longer moves.
Do not continue to press the On/Off
WARNING
switch after the machine has been auto-
matically switched off. The battery can be damaged.
Plug the mains plug of the battery charger into a socket
outlet and the charger plug 6 into the socket 5 on the rear
side of the handle.
The battery charge indicator 3 lights up green to indicate
the charging procedure. The battery is fully charged as
soon as the battery charge indicator 3 is no longer lit.
– During the charging procedure, the handle of the ma-
chine warms up. This is normal.
– Disconnect the battery charger from the mains supply
when not using it for longer periods.
– The power tool cannot be used during the charge pro-
cedure; it is not defective when inoperative during the
charging procedure.
Protect the battery charger against moisture!
Bosch Power Tools
English | 43
F 016 L70 560 | (25.11.08)