Charging Procedure - DeWalt DCD930 Manual De Instrucciones

10 charge/discharge cycles or whenever the pack no longer delivers
the same amount of work. To use the automatic Tune-Up™, place
the battery pack in the charger and leave it for at least 8 hours. The
charger will cycle through the following modes.
1. The red light will blink continuously indicating that the 1-hour
charge cycle has started.
2. When the 1-hour charge cycle is complete, the light will stay
on continuously and will no longer blink. This indicates that the
pack is fully charged and can be used at this time.
3. If the pack is left in the charger after the initial 1-hour charge,
the charger will begin the Automatic Tune-Up™ mode. This
mode continues up to 8 hours or until the individual cells in the
battery pack are equalized. The battery pack is ready for use
and can be removed at any time during the Automatic Tune-
Up™ mode.
4. Once the Automatic Tune-Up™ mode is complete, the charger
will begin a maintenance charge; the red indicator will remain
lit.
Chargers
Your tool uses a D WALT 14.4 or 18 volt charger. Be sure to read
E
all safety instructions before using your charger.

Charging Procedure

DANGER: Electrocution hazard. Do not probe with conductive
objects. Danger of electric shock or electrocution.
1. Plug the charger into an
appropriate outlet before inserting
battery pack.
2. Insert the battery pack into the
charger. The red (charging) light
will blink continuously indicating
that the charging process has
started.
3. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may
be used at this time or left in the charger.
Indicator Light Operation
Charge Indicators
Some chargers are designed to detect certain problems that can
arise with battery packs. Problems are indicated by the red light
flashing at a fast rate. If this occurs, re-insert battery pack into
the charger. If the problem persists, try a different battery pack to
determine if the charger is OK. If the new pack charges correctly,
then the original pack is defective and should be returned to a
service center or other collection site for recycling. If the new battery
pack elicits the same trouble indication as the original, have the
charger tested at an authorized service center.
HOT/COLD PACK DELAY
Some chargers have a Hot/Cold Pack Delay feature: when the
charger detects a battery that is hot, it automatically starts a Hot
Pack Delay, suspending charging until the battery has cooled. After
the battery has cooled, the charger automatically switches to the
Pack Charging mode. This feature ensures maximum battery life.
The red light flashes long, then short while in the Hot Pack Delay
mode.
9