Uline H-4590 Guia De Inicio Rapido

H-4590
U-CHANNEL
BASE ADAPTER
TOOLS NEEDED
Hammer
NOTE: For use with H-4588 and H-4589
rubber sign bases.
1. Turn the base upside down on a flat work surface so
the 4¼" diameter hole is facing up.
2. Use a hammer to pound the adapter into the base
until it bottoms out on the work surface.
(See Figure 1)
3. Turn the base right-side up, and, with your hands
supporting each side of the base, hit the plate of
the adapter against the flat work surface. Use the
weight of the base to drive the adapter completely
through the hole. (See Figure 2)
NOTE: The adapter plate should be flush
against the bottom of the base. If needed,
use a hammer to pound the plate against the
bottom of the base.
4. Place the base onto the flat working surface so
the adapter extension is facing upward. Using two
1/4 x 20 x 2" bolts, four 1/4" washers, and two 1/4" nuts,
attach the U-Channel sign post.
NOTE: Place the washers on each side of the
U-Channel assembly.
5. Attach the sign to the U-Channel using the two
1/4 x 20 x 1½" bolts, four 1/4" washers, and two 1/4" nuts.
NOTE: The sign should be attached to the
side of the U-Channel providing the greatest
stability. The sign should touch the wings of the
U-Channel sign post, not the hump.
PAGE 1 OF 3
1-800-295-5510
uline.com
7/16" Socket Wrench
ASSEMBLY
Para Español, vea página 2.
Pour le français, consulter la page 3.
Figure 1
Figure 2
0721 IH-4590