Tripp-Lite CST16AC Manual Del Propietário página 5

4. Setup
1
Determine the charging station tower's permanent mounting location
along the wall. Ensure the 10-ft. power cord and input plug are able to
connect to a nearby power outlet.
2 Use the included fold-out template to mark the locations where the
charging station tower's wall-mount brackets will be used to secure the
charging station tower to the wall
3
Install appropriate fasteners (not included) on the wall according to the
locations marked from the template in step 2. Use suitable mounting
means when installing to cinder block, concrete, drywall or wood studs.
Make sure to leave approximately 5 mm space between the hardware and the wall.
4
With the help of an assistant, lift the charging station tower and
align its keyhole slots with the mounting hardware. Then, push in the
charging station tower so it is flush against the wall and carefully lower
the charging station tower to the ground
The supporting surfaces must be able to safely support
the combined load of the equipment and all attached
hardware and components. The charging station
tower is not designed to hang from a wall and should
always be placed firmly on a ground surface. For more
information on your model's weight and dimensions,
refer to 5. Specifications in this manual.
5 If no further adjustments are needed, again with the help of an
assistant, lift the charging station and remove the unit from the
wall-mount hardware. Proceed to section 4.3 Connecting Power
Adapters.
A .
B .
5
WALL
A
TEMPLATE
FLOOR
2
B
4