Grease Filter - ELICA Oxygene Manual De Instrucciones

Panel
Fig. 2
Dismantling
Press the panel upward decisively, the panel will be released
and roll down freely. ALWAYS ACCOMPANY IT WITH YOUR
HAND DURING THIS OPERATION.
Unscrew safety knob S and remove the panel, unhooking it
from the attachment pins.
Cleaning:
The panel should be cleaned with the same frequency as the
fats filter, use a cloth soaked in neutral detergent liquids.
Avoid the use of products containing abrasives. DO NOT USE
ALCOHOL!
Montage:
Accompany the panel upward and press until the pins of the
panel fit correctly into the slot of the hood.
Attention! Always check that the panel is fixed well n its
place.

Grease filter

Fig. 3
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. When washed
in a dishwasher, the grease filter may discolour slightly, but
this does not affect its filtering capacity.
Remove the filter holder frame by turning the knobs (g) 90°
that affix the chimney to the cooker hood.
Charcoal filter (filter version only)
Fig. 5
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
using hot water and a suitable detergent, or in a dishwasher at
65°C (if the dishwasher is used, select the full cycle function
and leave dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
Assembly
Place the mat around the grease filter and fix it in place using
the devices provided.
Position the upper cap and fix it in place using the fixing pin.
To disassemble, perform the steps in the reverse order.
Replacing lamps
Fig. 4
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
1. Using a flat head screwdriver or equivalent tool, carefully
pry loose the light cover.
2. Remove the damaged light and replace with a new 12
Volt, 20 Watt (Maximum) halogen light made for a G-4
base SUITABLE FOR USE IN OPEN LUMINAIRES.
Follow package directions and do not touch new light
with bare hands.
3. Reinstall the light cover. (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
18