Setting And Starting A Washing Programme - Zanussi ZDT431 Manual De Instrucciones

4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons A and C
go off.
– The indicator light for function button B continues
to flash.
– The digital display shows the setting.

Setting and starting a washing programme

Set the washing programme with the door ajar. The
washing programme only starts after you close the
door. Until then it is possible to modify the settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press one of two programme selection buttons again
and again until the digital display shows number
corresponding to the required programme. Refer to
the chapter 'Washing programmes'.
4. Close the door.
– The washing programme starts.
When the washing programme operates, you cannot
change the programme. Cancel the washing pro-
gramme
Setting and starting a washing programme with
delay start
1. Press the on/off button.
2. Set a washing programme.
3. Press the delay start button until the display shows
the necessary delay start of the washing programme.
4. Close the door.
– The countdown of the delay start starts.
– The countdown of the delay start decreases with
steps of 1 hour.
– When the countdown is completed, the washing
programme starts automatically.
All manuals and user guides at all-guides.com
Rinse aid dispenser deac-
tivated
Rinse aid dispenser activa-
ted
6. Press function button B again.
– The digital display shows the new setting.
7. Switch off the appliance to save the operation.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid dispenser.
3. Adjust the water hardness setting to the highest level.
4. Do a washing programme without dishes.
5. Adjust the water softener to the water hardness in your
area.
6. Adjust the rinse aid dosage.
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you close
the door again, the countdown continues from the point
of interruption.
Cancelling a delay start
1. Press and hold function buttons B and C until the
digital display shows two horizontal lines (- -).
– When you cancel a delay start, you also cancel the
washing programme.
2. Set a new washing programme.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of interrup-
tion.
Cancelling a washing programme
1. Press and hold function buttons B and C until the
digital display shows two horizontal lines (- -).
2. Release function buttons B and C to cancel the wash-
ing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
29