VONROC SG501DC Traducción Del Manual Original página 6

EN
3. ASSEMBLY
The soldering tip has to be mounted before
initial use. See installing/replacing
soldering tip.
Make sure that the soldering iron is turned
off and cold.
Soldering iron base (Fig. A)
• Place the soldering iron base (5) on the table/
flat surface.
• Put the soldering iron (3) into the base (5).
• Ensure that it is firmly placed.
• Fit the sponge (6) on the soldering iron base (5)
and lightly moisten the sponge with some tap
water.
Tip! Make sure to absorb the sponge (6) in water
before using the soldering iron (3) and keep the
sponge damp at all times during use.
Installing /replacing soldering tip (Fig. B)
Make sure that the soldering iron is turned
off and cold.
• To install the soldering tip, hold the soldering
iron and screw the soldering tip (1) tightly into
the soldering tip holder (2)
• To replace the soldering tip (1), unscrew the
soldering tip (1) that is already inserted and
take it off, then screw the new soldering tip (1)
into the soldering tip holder (2).
4. OPERATING
The battery must be charged before first
use.
Charging the machine (Fig. C)
The device cannot be used while it is being
charged.
• Plug the charger cable (included) into an adapter
(not included).
• Plug the charger cable (8) into the machine.
• Plug the charger plug into an electrical outlet
and wait for a while. The LED indication light (9)
will lighten up and show the charging status.
• Note: the machine can also be charged by con-
necting the charger cable to a suitable USB outlet.
6
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
Fully charging the battery may take up to 2 - 3 hours.
If the LED indicator light (9) is red and flashing,
when this happens there is problem with the
battery. Stop charging immediately and consult a
qualified electrician or a service workshop.
Switching on and off
Caution, danger of burns! Do not touch the
hot soldering tip.
When starting work:
1. Take out the soldering iron (3) from the soldering
iron base (5).
2. Hold the soldering iron in your hand like a pen,
as shown on figure D.
3. Press the on/off switch (4) to turn on the ma-
chine, the LED indicator light (9) turns red. The
LED working lights (10) will turn on to bright up
the working area.
4. The indicator light (9) changes from red to
green after approx. 25 seconds; now the solde-
ring tip has reached a working temperature of
approx. 450°C.
5. The soldering tip will keep the temperature for
10min, after this the soldering iron stops auto-
matically and the LED indicator light (9) and the
LED working lights (10) will turn off.
6. To continue using the soldering iron, repeat
step 2 to 4.
Switching off:
• Press the on/off switch (4) to turn off the machi-
ne. Make sure that the hot soldering tip (1) does
not touch anything until it has cooled down.
• Cleaning the solder tip on the wet sponge (6)
• Put the soldering iron back on the soldering iron
base (5).
Working Instructions
• In order to obtain a perfect soldering point, the
soldering point must be completely clean and
free of grease.
• Before initial use, the soldering tip has to be
tin-coated, i.e. coated with soldering tin. Only
good tin coating ensures perfect soldering and
WWW.VONROC.COM