Putting On The Carrying Strap; Operation; Switching On And Off - Parkside PLSA 40-Li C2 Traducción Del Manual De Instrucciones Original

3. Hook the carabiner (14) of the collec-
tion bag into the eyelets (19) provided
on the motor housing.
Adjusting the additional handle
The additional handle (11) can be locked
in various positions.
1. Press the angle adjuster (17) on the ad-
ditional handle (11).
2. Adjust the additional handle to the de-
sired position.
3. Release the angle adjuster (17).
Putting on the carrying
strap
Never wear the carrying
strap diagonally across your
shoulders and chest: only
wear it on one shoulder to
ensure you can detach the
device quickly from your
body in the event of danger.
Pulling the push-fit lock (21) releases
the device quickly from the carry-
ing strap. To open the push-fit lock,
press the two clamps together.
1. Place the carrying strap (13) on one
shoulder.
2. Adjust the strap length so that the snap
hook is approximately 10 cm below
your hip.
3. Attach the snap hook on the eyelet (12)
to insert the strap.

Operation

Caution! Risk of injury!
Always wear appropriate
protective equipment and
work gloves while working
with the device. Prior to each
use, ensure that the device
is working correctly. Ensure
that the device has been
mounted properly.
Stop using the device if the
On/Off button is damaged.
Personal protective equip-
ment and a fully functional
device reduce the risk of inju-
ries and accidents.
After the device has been
switched off, the impeller
continues moving for some
time. Injury hazard caused
by rotating tool!
Observe noise protection rules and
other local regulations.

Switching on and off

The cordless leaf vacuum/blower
may only be used with two batteries
of the Parkside X 20 V Team series.
Before switching the device on,
make sure that it is not touching any
objects. Ensure secure positioning.
1. Press and hold the on/off switch (4) to
start the device.
2. In order to regulate the suction/blow-
ing power, press the volume
control (3).
Pressing
Pressing
The 4 LEDs below the charge level
indicator (18) indicate the level of the
suction/blowing power.
GB
= one level higher
= one level lower
IE
35