Initial Start-Up; Charging The Battery; Remove/Insert Battery; Assembling/Dismantling The Blowpipe - Parkside PLSA 40-Li C2 Traducción Del Manual De Instrucciones Original

may impair the functionality
of active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, users who wear medi-
cal implants must consult their
doctor and the manufacturer
of the implant before operat-
ing the machine.

Initial start-up

Before operating the device, you must
- insert both rechargeable batteries,
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- insert the protective cover for leaf
blowing.
The cordless leaf vacuum/blower
has a safety contact, which is
located in the motor housing (
1), where the protective cover (
7) or the suction pipe (
is mounted.
are not activated, the de-
vice cannot be started!
Pay attention to the correct assembly
- protective cover (7) for blowing
mode;
- suction pipe (16) for vacuum
mode.
Caution! Risk of injury! Dur-
ing the assembly or disas-
sembly of the blowpipe,
suction pipe, protective cover
or collection bag, the device
must be turned off and all
moving parts must have
come to a standstill. Remove
the batteries before carrying
out any work!
If these contacts

Charging the battery

Ensure that the ambient tem-
perature does not exceed
40 °C or fall below 4 °C dur-
ing the charging process.
If warm, allow the battery to cool
before charging.
Do not expose the battery to direct
sunlight for long periods and do
not place it on a radiator (max.
50°C).
1. Remove the rechargeable batteries (5)
from the device, if necessary.
2. Slide the rechargeable batteries (5)
onto the charger (6) up to the stop.
3. Plug the charger (6) into a socket.
4. Once charging is complete, disconnect
the charger (6) from the mains supply.
5. Remove the battery (5) from the
charger (6).
16)

Remove/insert battery

1. To remove the battery (5) from the de-
vice, press the release button (5.1) on
the battery (5) and pull the battery out.
2. To insert the battery (5), push the bat-
tery (5) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Assembling/dismantling
the blowpipe
Never use the leaf blower
with only one blowpipe sec-
GB IE
33