GYS SPOT LIFT PRO MOB Manual De Instrucciones página 14

Translation of the original instructions
4/ LOWERING
Remove the safety links.
To get the product down, push continuously the joystick down. The joystick always comes back to its initial position in
order to make sure that all the operations are intentional.
SAFETY MEASURE
- The SPOT LIFT PRO must be used by trained and authorized people. Moreover, they must have read this user
manual. It must be read carefully before using the SPOT LIFT PRO MOB.
It is forbidden to lift people wit this product.
• Check the load, especially when lifting, while ensuring there is no anomaly. In the event of an issue, the SPOT LIFT
PRO MOB must go down as soon as possible and postionned correctly.
• Clean the vehicle supporting surface, make sure that there is no oil or grease which may maje the vehicle slip
• This product is solely a lifting tool. After lifting the vehicle, it must be supported by safety links.
• Do not put the pads on an area next to airbags sensors or on an area covered with plastic .
• Do not put the pads on an area covered with plastic .
• The tool is equipped with a safety valve whcih opens itself when the pressure inside the airchambers is too high (5.5 bar)
• Check that the input pressure is ≤ 8 bar. If necessary, use a pressure regulator.
• Once the work is done, systematically lower the load down to the ground so the SPOT LIFT PRO MOB does remain
under a full load for a long period of time.
• The device must not be used in an explosive atmopshere and it preferable to not work close to a heat source (risque
of explosion in the air chambers).
• It is forbidden to use the device on a boat (stability issues).
• It is forbidden to use spare parts other than the ones ceritfied by GYS.
• Do not lift loads other than the ones the SPOT LIFT PRO MOB is designed to lift.
• If in doubt about the solidity of the vehicle (rust) - Do not lift the vehicle.
• Do not use in highly humid environments. The device must not be submerged.
Water going ionside the device may damage the pneumatic system.
Recommendation : It is recommended to use a receiver drier on the compressor, to reduce the risks of humidity.
• Do not perform any modifications on the machine
CONTROLS AND MAINTENANCE
The SPOT LIFT PRO MOB does not require specific maintenance. A basic periodic visual check is recommended to
prevent any breakdown or failure during use. If a check up is needed, it must be done without a load.
Apply grease regularly to the axles and any part subject to friction. Regularly check that the air chambers and com-
pressed air pipes are not cracked or damaged. If that happens they will need to be replaced.
14
SPOT LIFT PRO MOB
Before lowering the SPOT LIFT PRO MOB, make sure that no electric cable or object are going
through the scissors.
EN EN