Working Position - GYS SPOT LIFT PRO MOB Manual De Instrucciones

Translation of the original instructions
=
GYS accepts no responsibility in case of damaged causes to people if the operator does not res-
pect recommendations.

2/ WORKING POSITION

Once the operation is done and before starting your work on the vehicle, make sure you have check the stability of the
vehicle on the SPOT LIFT PRO.
3/ MOVING THE VEHICLE
Remove the safety links.
Place the wheel supports near the pads and lock it.
To lower the SPOT LIFT PRO MOB, reconnect the air supply and push
the jotstick down until the support's wheels touch ground.
At this stage, activate the «venturi» function, then push the joystick down so the
SPOT LIFT PRO MOB scissors will go back up.
Safely move the vehicle.
Wear safety shoes.
To resume work, deactivate the «venturi» function then push the joystick up to lift
the car.
Remember to put the safety links back.
To remove the wheel supports, Unlock the safety lever and remove the pin.
SPOT LIFT PRO MOB
YES
=
NO
=
EN EN
=
13