GYS SPOT LIFT PRO MOB Manual De Instrucciones página 12

Translation of the original instructions
SAFTEY AREA
For an optimal safety, it is recommended to make sure that any other objects or walls are away. Any
handling work must be done with care from the operator. Nobody must be stand in the safety area.
In order to secure the operator, the command remote box must be situated at a distance where the
operator can get away easily in case of emergency.
INDIVIDUAL PROTECTION
The operator must be equipped following prevention standards and must take the necessary actions to maintain
safety. During manoeuvres, the operator must protect his safety and people safety. The operator must take into
consideration all the recommendations quoted in this manual.
INSTALLATION
Once the product out of is packaging , assembled and on the floor, make a try to check the good functionning. The
command panel is attached to the lever.
Start and verification (attempt)
- Screw the compressed air connexion tip on the command remote box and connect it to the
compressed air circuit.
- Check that the pressure is correct (Max 8 bar).
- Check that there is no air leakage and that the cable is not damaged.
LIFTING CHECK:
After performing the verifications listed above, push the joystick up continuouly in order to raise
the SPOT LIFT PRO MOB. Once the maximum height is reached, releease the joystick in order
to put it back on its initial position. Disconnect the air supply to make sure that the SPOT LIFT
PRO MOB does not lower.
LOWERING CHECK:
Before any operation, make sure that nothing is under the SPOT LIFT PRO.
To get the product to lower, check that the air supply is connected and continuously push the
joystick down. The SPOT LIFT PRO will go down to its lowest point.
If these 2 steps have been successful, the product is ready to use.
INSTRUCTIONS
1/ LIFTING OPERATIONS
WARNING: Before lifting a vehicle, make sure that the hand brake is released, that the vehicle is on
neutral and that tyres pressure is enough to maintain the vehicle in balance.
Position the SPOT LIFT PRO MOB under the vehicle and centre
it widthwise. Extend arms until that the rubber pads are in posi-
tion, in accordance with the car manufacturer's recommenda-
tions. Pads are height adjustable. Fix the height with the small
bar in order to be as close as possible of the lowest part of the
vehicle. Once the tool is positioned, proceed with the lifting
operation:
Check that no bulky objects are in the safety area
- Push the joystick up until the height is sufficient
- Stop the lifting by releasing the joystick.
After lifting the vehicle, it must be support by 2 safety links, which must be locked using the safety pins. (Do not go
under the vehicle to position them)
- Push the joystick down fo the SPOT LIFT PRO MOB rests on the safety links, which will secure the load.
- Disconnect the air hose from the control panel so you may move around the vehicle freely.
12
SPOT LIFT PRO MOB
EN EN
Descente
Air
Venturi
Montée