Hardware Description - GYS WCU 0.5KW A Manual De Instrucciones

Translation of the original instructions
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorized by the manufacturer should perform the installation of the welding equipment. During set up, the operator must
ensure that the machine is unplugged.

HARDWARE DESCRIPTION

The cooling unit is a system designed to cool the water cooled torches connected to your TIG :
Compatibility TIG 220 DC
WCU 0.5 KWA
WCU 1 KWA
WCU 1 KWB -
The WCU1KWA and WCU1KWB cooling units feature:
- with a water level protection making sure the filling is at the minimum level for the good functioning of the cooling system but also for a good torch
cooling.
- with a water flow protection in order to protect the torch against a blockage at the level of the water circuit or a damage of the torch connection.
The recommended cooling system unit is automatically detected by the machine. In the OPTION menu, this cooling unit system can be deactivated.
Warning ! Do not plug the cooling unit whilst the TIG machine is on.
INSTALLATION AND CONNECTION
TIG 220 DC
1
Unclip the plastic cover.
2
Unscrew 2 screws at the front and 2 screws at the rear of the
WCU 0.5KW A / 1KW A / 1KW B
TIG 300 DC TIG 220 AC/DC
- -
-
-
machine.
This device is controlled directly by the welding machine via two
connection cables.
TIG 220 AC/DC - TIG 300 DC
Unclip the plastic cover.
Unscrew 3 screws on each side of the machine (6 in total)
EN
9 9