GYS NOMAD POWER 500 Manual De Instrucciones página 11

Translation of the original instructions
3
4
5
6
7
«BOOST» function
When the vehicle battery is too discharged, the NOMAD POWER cannot start.
The NOMAD POWER 500 is equipped with a «BOOST» function to force start.
1
2
CHARGING MOBILE PHONES
NOMAD POWER 500
If the operating LED (8) flashes green, the device is ready.
If the LED (8) ligts red and an audible alarm sounds, refer to the table on page 12.
Performing a start.
Do not exceed 4 start attempts with a time interval of 30 seconds between
!
each.
After starting, disconnect the smart start cable from its connector (5) and remove the 2
camps from the vehicle's battery terminals within 30 seconds.
Leave the vehicle running.
!
If the vehicle still does not start after 4 attempts, the LED (8) flashes alternately red and
green.
Wait 120 seconds and then try to start again.
If the vehicle still does not start, consult a professional.
!
DO NOT reboot.
After the start-up, if the internal battery is less than 80%, recharge the NOMAD POWER.
Wait at least 30 minutes after starting the vehicle to charge the NOMAD
!
POWER.
The LED (8) does not light to indicate that the voltage at the battery terminals is
too low.
Press the «BOOST» button (6) for a long time (> 3s) and wait until the LED (8)
turns green.
BOOST
Perform a startup within 30 seconds before the NOMAD POWER automatically exists the «BOOST» mode.
1- Plug your cable to the NOMAD POWER USB port 1 (3-4)
2- Select the appropriate adaptor for your mobile phone or table and plug it in.
The NOMAD POWER launches the charge automatically.
EN
11