Maintenance And Servicing; Maintenance And Cleaning - Berner BROS-125 AVE Manual Original

changing the orbital stroke rate level; the random
orbit motion will be retained.
Move the power tool with moderate pressure flat
on the workpiece in a circular motion or altern-
ately along and across it. Do not tilt the power tool
in order to avoid sanding through the workpiece,
e.g. veneers.
Switch the power tool off after completing opera-
tion.
Polishing
English
For polishing weathered lacquers and redressing
scratches (e.g. acrylic glass), the power tool can
be fitted with an appropriate polishing tool, e.g.
lambswool bonnet, polishing felt or polishing
sponge (accessory).
Select a low orbital stroke rate (level 1–2) when
polishing in order to avoid heating up the surface
excessively.
Application
Intermediate lacquer sanding
Lacquer/varnish
Softwood
Hardwood
Veneer
Aluminium
Steel
Derusting steel
Stainless steel
Stone

Maintenance and Servicing

Maintenance and Cleaning

Pull the plug out of the socket before carry-
u
ing out any work on the power tool.
To ensure safe and efficient operation, al-
u
ways keep the power tool and the ventilation
slots clean.
In order to avoid safety hazards, if the power sup-
ply cord needs to be replaced, this must be done
by Berner or by an after-sales service centre that
is authorised to repair Berner power tools.
Disposal
English
The power tool, accessories and packaging
should be recycled in an environmentally friendly
manner.
Do not dispose of power tools along
with household waste.
1 609 92A 4DE • 14.1.19
Apply the polish to an area slightly smaller than
the area which you intend to polish. Using the ap-
propriate polishing tool, work in the polish with
either linear or circular movements and with mod-
erate pressure.
Do not allow the polish to dry out on the surface;
this may damage the surface. Do not expose the
surface which you intend to polish to direct sun-
light.
Clean the polishing tool regularly to ensure good
polishing results. Wash the polishing tools with
mild detergent and warm water; do not use thin-
ning agents.
Application Table
The information in the table below is the recom-
mended values.
The best method for determining the best com-
bination while sanding or polishing is practical ex-
perimentation.
(coarse/fine sanding)
120/400
240/320
120/240
Only for EU countries:
According to the European Directive 2012/19/EU
English
on Waste Electrical and Electronic Equipment and
its implementation into national law, power tools
English
that are no longer usable must be collected separ-
ately and disposed of in an environmentally
friendly manner.
English
Grit Orbital stroke rate level
40/80
40/240
60/320
80/240
60/240
40/120
80/200
English
5/6
5/6
5/6
5/6
5/6
5
5
6
5
6
English | 17