Medtronic GUARDIAN LINK Manual De Instrucciones página 12

pattern of four flashes with a pause between the four flashes.
3 When charging is complete, the green light on the charger will
stay on, without flashing, for 15 to 20 seconds and then turn off.
4 After the green charger light turns off, disconnect the
transmitter from the charger. The green light on the transmitter
starts to flash.
Pairing your transmitter
Always refer to the system user guide for instructions on how to pair your transmitter with
your pump. The pump and the transmitter must be paired before data from the sensor
can be sent to the pump. The pump and the transmitter are only required to be paired
once. There is no need to pair the pump with the transmitter again when you insert a new
sensor.
Inserting the sensor
Always refer to your sensor user guide for instructions on how to insert the sensor.
Connecting the transmitter to the sensor
Before proceeding, have your MiniMed™ insulin pump system user guide available.
To connect the transmitter to the sensor:
1 After the sensor is inserted, consult your sensor user guide for details on how to
apply the required tape before connecting the transmitter.
2 Hold the rounded end of the inserted sensor to prevent it from moving during
connection.
3 Hold the transmitter as shown. Line up the two notches on the
transmitter with the side arms of the sensor. The flat side of the
transmitter should face the skin.
4 Slide the transmitter onto the sensor connector until the sensor
arms snap into the notches on the transmitter. If the transmitter
is properly connected, and if the sensor has had enough time to
become hydrated with the interstitial fluid, the green light on the
transmitter will flash 6 times.
Note: If the transmitter does not flash, see Troubleshooting, on page 19.
-6-