Troubleshooting - TECshow LycoZoom 50 Manual De Usuario

8. TROUBLESHOOTING

Problems
Fixture does not light up
General low light intensity
Fixture does not power up
Fixture does not respond
to DMX
Contact an authorized service center in case of technical problems or not reported in the table can not be
resolved by the procedure given in the table.
Possible causes
• No mains supply
• Dimmer fader set to 0
• All color faders set to 0
• Faulty LED
• Faulty LED board
• Dirty lens assembly
• Misaligned lens assembly
• No power
• Loose or damaged power
cord
• Faulty internal power
supply
• Wrong DMX addressing
• Damage DMX cables
• Bouncing signal
Checks and remedies
• Check the power supply voltage
• Increase the value of the dimmer channels
• Increase the value of the color channels
• Replace the LED board
• Replace the LED board
• Clean the fixture regularly
• Install lens assembly properly
• Check for power on power outlet
• Check power cord
• Replace internal power supply
• Check control panel and unit addressing
• Check DMX cables
• Install terminator as suggested
P. 11
| LycoZoom 50
English version