Malfunctions; Corrective Action - SATA jet 1000 K RP Instrucciones De Servicio

Operating Instructions SATAjet 1000 K (RP / HVLP) / H (RP)
Damage from incorrect cleaning tool
Never use unsuitable objects to clean clogged holes. Even the tiniest
damage can influence the spray pattern.
→ Use SATA nozzle cleaning needles (# 62174) or (# 9894).
Notice!
In rare cases, it may be necessary to dismantle some parts of the spray
gun to clean them thoroughly. If dismantling should be necessary, this
should be limited just to the parts whose function brings them in contact
with the material.
■ Purge spray gun thoroughly with thinner.
■ Clean air cap with a paint brush or brush.
■ Lightly grease moving parts with high performance grease.

11. Malfunctions

The malfunctions described below may only be remedied by trained per-
sonnel.
If it is not possible to remedy a malfunction with the described corrective
actions, send the spray gun to the SATA customer service department
(address see chapter 17).
Malfunction
Jerky spray fan pat-
tern (wobbling / splut-
tering) or air bubbles
in suction cup.
Attention!
Cause
Fluid tip not tightened. Tighten fluid tip with
Air distribution ring
damaged or clogged.

Corrective Action

universal spanner.
Replace air distribution
ring (see chapter 9.2).
EN
141