Troubleshooting - Glacier bay FP4A0052BNV Guía De Uso Y Cuidado

Troubleshooting

Problem Possible Cause
There are leaks The retainer nut has come loose
underneath the and the O-ring on the cartridge is
handle. dirty or damaged.
The aerator leaks or The aerator is dirty or mis-fitted.
has an inconsistent
water flow pattern.
There are leaks The hose and spray head
from the hose un- connection may be loose.
derneath the deck.
The hose does not The weight is not installed in the
retract. appropriate position.
The water pressure The quick connector is clogged with
is low. debris.
There is no hot or The water supply line was acc-
cold water. cidentally kinked during installa-
tion and is limiting the water flow
through.
Tighten the retainer nut.
Clean or replace the O-ring.
Remove the aerator and check for
debris in the aerator screens.
Confirm that the rubber washer is
properly installed.
Tighten the connection between the
spray head and hose.
Reinstall or readjust the weight.
Turn off the water supply and disconnect the
quick connector from the discharge tube.
Unscrew the quick connector from the hose and
clean under running water.
Screw the quick connector back onto the hose
and connect back to the discharge tube.
Test water flow. If water pressure is still low then
replace the quick connnector.
Reinstall the water supply line.
10
Solution