Protecting The Environment - DeWalt D24000 Traducido De Las Instrucciones Originales

• Remove the water collectors.
• Lift the machine out of the water basin as shown.
• Place the collectors into the water basin in the orientation as shown.
• Turn the water basin upside down.
• Place the edge guide and the extension table into the water basin in
the orientation as shown.
WARNING: When carrying the machine, always seek
assistance. The machine is too heavy for one person to
handle.
Maintenance
Your D WALT power tool has been designed to operate over a long period
E
of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Draining the water basin (fi g. X)
The water basin must be drained after each use.
• Place the water pump on the tray (75).
• Place a suitable container under the drain plug (29).
• Remove the drain plug.
• Allow ample time for the liquid to drain.
• After the liquid has been drained, re-install the drain plug.
• Dispose of the liquid with due care for the environment.
Adjusting the table rolling resistance (fi g. Y)
To take out the clearance between the table and the rails, proceed as
follows:
• Loosen the rail height screws (76).
• Adjust the rail height adjusters (77) until the table moves smoothly.
• Tighten the rail height screws.
Cleaning
Before use, carefully check the cutting disk guard to determine that it will
operate properly. Ensure that mud, or work-piece particle cannot lead to
blockage of one of the functions.
In case of workpiece fragments jammed between cutting disk and guard
disconnect the machine from the power supply and follow the instructions
given in section "Mounting the cutting disk". Remove the jammed parts
and reassembling the cutting disk.
Keep the ventilation slots clear and regularly clean the housing with a soft
cloth.
The following cleaning operations must be performed every day.
• Insert the water pump into a bucket of clean water and pump the water
through the hose system.
• Wipe the rails and support arm with a grout sponge or a rag.
• Spray the water basin and the sliding table with clear water. Wipe any
dust residue away with a grout sponge.
Lubrication
Your power tool requires no additional lubrication.

Protecting the environment

Separate collection. This product must not be disposed of with
normal household waste.
Should you fi nd one day that your D
if it is of no further use to you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products and packaging allows
materials to be recycled and used again. Re-use of recycled
materials helps prevent environmental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate collection of electrical products
from the household, at municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and recycling of D
E
products once they have reached the end of their working life. To take
advantage of this service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised repair agent by
contacting your local D WALT offi ce at the address indicated in this
E
manual. Alternatively, a list of authorised D
details of our after-sales service and contacts are available on the Internet
at: www.2helpU.com.
E N G L I S H
WALT product needs replacement, or
E
WALT
E
WALT repair agents and full
E
39