Erase Codes - Tele Radio T60 Manual De Instrucciones

The red diode (no. 6) flashes as an indication that the transmitter's adjusta-
ble code has been saved.
Adjustable code and fi xed individual code
1. Select the program option "Self-instruction of code" (RED diode) using
the function button.
2. Confirm using the select button.The red diodes above the relays light.
3. It is possible by using the function button to scroll to the relay/relays to
be coded.
- When an individual relay is selected it will be controlled by the trans-
mitter button used during instruction.
- When all relays are selected the system will function as normal.That
is say, the transmitter's first button will control relay 1, button 2 will
control relay 2, etc.
4. Confirm that the adjustable code and fixed individual code are to be
programmed as follows:
- Press down the select button and release it after 0.3 - 4 seconds.
- Press down the select button within 1 second and keep it held down
for at least 1 second.
5. Program the transmitter's code by holding down the appropriate trans-
mitter button until the red diode no. 6 flashes three times.
RED diode (no. 6) double flashes to indicate that the transmitter's adjusta-
ble and fixed individual code have been saved.

Erase codes

1. Select the program option "Self-instruction of code" (RED diode).
2. Confirm using the select button.The red diodes above the relays light.
3. Use the function button to scroll to the relay/relays to be erased.
4. Hold down the select button until the diode/diodes above the relays go
out (at least 6 seconds).
PROGRAMMING THE MOMENTARY / LATCHED FUNCTION
The receiver's relays have an momentary function as standard.
1. Select the program option "momentary/latched function" (YELLOW
diode) using the function button.
165