Wilo TR/E 216 Serie Instrucciones De Instalación Y Funcionamiento página 23

2
11
9
Fig. 6: Mixer set down on stand
Fig. 7: Additional rope anchoring
Installation and operating instructions Wilo-EMU TR/TRE 216 ... 326-3
Installation and electrical connection
Completing installation
1 Hoist
2 Lifting equipment
1 9 Guide pipe for lowering device
11
Connection cable
‡
Mixer mounted on the lowering device
1. Slowly lower the mixer.
- Hold the connection cable slightly taut when lowering it.
- Do not damage the connection cable. Do not lead it directly over the edge of the
basin!
NOTICE! Alternatively, anchoring can be done via a separate nylon rope. An anchor-
ing set is included in the accessories for this purpose.
2. Lower the mixer until it reaches the end of the guide pipe.
3. Anchor the connection cable with the cable bracket on the edge of the basin.
▶ Installation is complete. Lay the connection cable and make the electrical connection.
Installing additional rope anchoring
The additional rope anchoring protects the connection cable against damage in the event of
powerful flow in the basin. The rope anchoring consists of a 12 mm nylon rope (PA6) and a
corresponding number of cable brackets. The quantity and size of the cable brackets de-
pend on the order.
WARNING! Only use nylon rope and cable brackets for anchoring the connection cable.
Securing heavy loads or external products is strictly forbidden!
NOTICE! Install nylon rope in the length delivered. If the nylon rope is shortened, the
ends must be fused with a heat gun and secured against unravelling with heat-shrink
tubing!
‡
Submersible mixer completely installed.
1. Guide nylon rope through a free eyelet on the frame and knot it securely.
2. Pull nylon rope taut by hand (tensile force approx. 10 ... 15 kg).
3. Securely attach nylon rope to appropriately dimensioned parts of the construction (e.g.
railings, top holder etc.).
4. Attach first cable bracket directly to the frame. Firmly attach all connection cables to
the nylon rope with this cable bracket. NOTICE! Do not tighten connection cable! The
connection cables must form a loop!
5. Use the additional cable brackets to attach the connection cables to the nylon rope.
Max. distance between the cable brackets: 1 m. CAUTION! The nylon rope may stretch
in water. The connection cables must sag approx. 10 cm when the nylon rope is taut!
en-US
23