Troubleshooting Guide; Tape Playback; Radio Reception - Sony XR-C9100R Manual De Instrucciones

Troubleshooting guide

The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connection and operating procedures.
General
Problem
No sound.
The contents of the memory
have been erased.
Indications do not appear in the
d i s p l a y .

Tape playback

Problem
EN
Playback sound is distorted.
The AMS does not operate
correctly.

Radio reception

Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
The "ST" indication flashes.
40
Cause/Solution
•Cancel the ATT function.
•Set the fader control to the centre position for two-speaker
systems.
•Rotate the dial in a clockwise direction to adjust the volume.
• The power cord or battery has been disconnected.
• The reset button has been pressed.
n Store again into the memory.
Remove the front panel and clean the connectors. See "Cleaning
the connectors" (page 38) for details.
Cause/Solution
Contamination of the tape head.
n Clean the head.
• There is noise in the space between tracks.
• A blank space is too short (less than four seconds).
• The SEEK/AMS control is pushed up immediately before the
following tracks.
• The SEEK/AMS control is pushed down immediately after the
track starts.
• A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
Cause/Solution
• Memorise the correct frequency.
• The broadcast signal is too weak.
The broadcast signal is too weak.
n Use manual tuning.
•Tune in the frequency accurately.
•The broadcast signal is too weak.
n Set to MONO mode (page 11).