Final Check List Before - Silver Cross SIMPLICITY INFANT CARRIER Manual De Instrucciones

Tabla de contenido
Refitting the covers
Pull the cover over the sides of
the infant carrier. Make sure the
internal safety harness is threaded
through the cutouts in the cover.
Insert the cover into the sides of the
two blue seat belt guides and the
two sun/wind canopy connection
points. Fasten the eight connecting
studs, and the two press studs to
complete the refitting of the cover.
Slide the head support cover over
the plastic insert, and slide the
shoulder straps through the head
support cover, fasten the two press
studs to complete the refitting of
the cover.
Open the velcro fastening on the
chest pads and refit.
Make sure there are no twists in the
harness.
It is very important that the
chest pads are refitted. They
are an important safety feature,
and should always be used.
Cleaning the infant carrier shell
and harness
Wipe clean using a mild hand
soap and warm water. You must
not use detergents, solvents or
strong soaps. This may weaken
your infant carrier shell or harness.
You must not remove, dismantle or
alter any part of the infant carrier
shell or harness. You must not oil
or lubricate any part of your infant
carrier shell or harness.
Cleaning the covers
and chest pads
Hand wash only at a maximum of
30 degrees (see wash care label
on the back of the Simplicity Infant
Carrier seat cover). Do not iron, dry
clean or tumble dry. Dry flat, away
from direct heat and sunlight.
Cleaning the crotch strap
buckle
Clean the crotch strap buckle with a
mild hand soap and water and then
thoroughly rinse with warm water.
Leave to dry and DO NOT OIL OR
LUBRICATE any part of the buckle.
Final checklist before journey
Check
• The Simplicity Infant Carrier
must always be rearward facing
(with your child facing the back
of the vehicle).
• You have NOT fitted the
Simplicity Infant Carrier on a
passenger seat fitted with a
front airbag.
• You have adjusted the harness
to the correct position.
• The handle is firmly clicked into
the "In Car Position" see p.8.
• You have correctly routed the
vehicle 3 point lap and diagonal
seat belt as per the
manufacturer's instructions.
21
Tabla de contenido
loading

Tabla de contenido