EGO ST1210E Manual Del Operador página 10

WARNING:
EN To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
MOUNTING THE GUARD (Fig. B & C & D)
WARNING:
Always wear gloves when mounting or
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING:
Never operate the tool without the
guard firmly in place. The guard must always be on the
tool to protect the user! When the guard was fixed, never
attempted to remove or adjust the guard, if replace needed,
it shall be performed by a qualified service technician!
Face the trimmer head up, loosen and remove the two
screws. Then align the guide ribs with the housing slots,
push the guard into place and lock it with the two screws.
Make sure that the internal surface of the guard faces
towards the trimmer head.
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
Push the front-assist handle onto the shaft (Fig. F), then insert
the clamping block into the handle slot (Fig. G), mount the
lock pole, lock them with the wing nut (Fig. H). The sequence
is as Fig. E shown. Lastly, adjust the front-assist handle
position to make your front arm is straight when using the
trimmer (Fig. I) and then lock the lever of the lock pole (Fig. J).
Fig. E & I parts description see below:
E-1 Front-assist Handle
E-2 Lock Pole
E-3 Clamping Block
NOTICE:
The front-assist handle should be turned
upwards to point toward the top of the handle.
WARNING:
Only fix the front-assist handle in front of
the soft sleeve on the shaft.
WARNING:
The tool can not be used without the
front-assist handle reliably fixed.
OPERATION
WARNING:
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side
shields. Along with hearing protection. Failure to do so
could result in objects being thrown into your eyes and
other possible serious injuries.
10
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1210E
E-4 Wing Nut
I-1 Soft Sleeve
I-2 Warning Label
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING:
Use your line trimmer equipped with the
appropriate cutting line only for cutting grass and similar
material.
WARNING:
To prevent accidental starting that
could cause serious personal injury, always remove the
battery pack from the tool when assembling parts making
adjustments, cleaning, or when not in use.
You may use this product for the purposes listed below:
Trimming: used for removing grass and weeds up against
walls, fences, trees and borders.
Cutting: used for cutting the grass that is difficult to
reach using a normal mower.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use, for example edge trimming, is
deemed to be a case of misuse
ATTACHING/DETACHING THE BATTERY PACK
Fully charge before first use.
To Attach (Fig. K)
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a "click".
To Detach (Fig. L)
WARNING:
Always take care of your feet and
children or pets around you when pressing the battery
release button. Serious injury could result if the battery
pack falls. NEVER remove the battery pack at a high
location.
Depress the battery-release button and pull the battery
pack out.
HOLDING THE LINE TRIMMER
WARNING:
Dress properly to reduce the risk of
injury when operating this tool. Do not wear loose clothing
or jewelry. Wear eye and ear/hearing protection. Wear
heavy, long pants, boots and gloves. Do not wear short
pants, sandals or go barefoot.
Before operating, hold the trimmer with both hands, one
hand on the rear handle and the other on the front-assist
handle which shall be straight (Fig. M). Then check for
balanced footing and a proper cutting distance.