Temperature Information; C/°F Temperature Display; Temperature Trend Display; Temperature Alert Setting - THINK GIZMOS TG504 Manual Del Usuario

5. TEMPERATURE INFORMATION

5.1 °C/°F Temperature Display
The temperature is displayed either in °C/°F. Briefly pressing the '°C/°F' button allows you to
switch between the individual modes.

5.2 Temperature Trend Display

After you insert the batteries, the weather station measures the current temperature. The
trend display shows a neutral temperature course (horizontal arrow). The further course of
the trend display is determined as follows:
● If, after an hour, the temperature is more than 1°C higher than the value measured first,
then a positive course is displayed (arrow pointing upwards).
● If, after an hour, the temperature is more than 1°C lower than the value measured first,
then a negative course is displayed (arrow pointing downwards).
● If the temperature does not change within an hour, the the upward or downward
pointing arrow becomes a horizontal arrow. The measured temperature is then taken as
the neutral value from which further prognoses are made.

5.3 Temperature Alert Setting

Press and hold down the 'ALERT' button for 2 seconds until the con for Temperature
●
Alert starts to flash.
The icon of Upper limit of the alarm will flash. Use the 'MPA/INHG' and '°C/°F' buttons
●
to set the required maximum temperature. Press the 'ALERT' button to confirm the
settings.
The icon of Lower limit of the alarm will flash. Use the 'MPA/INHG' and '°C/°F' buttons to
●
set the required minimum temperature. Press the 'ALERT' button to confirm the settings
and to end the settings procedure.
● When Temperature Alert is On Alert: there are 3 beep sounds per second, the alarm will
sound for 1 minute if you do not deactivate it with any button.

5.4 Maximum/Minimum Temperature

To toggle indoor/outdoor maximum, minimum temperature press the 'MEM' button:
● Once to show the maximum temperature values.
● Twice to show the minimum temperature values.
● Three times to return to the current temperature levels.
● To reset the maximum and minimum temperature, press and hold down the 'MEM'
button for about 2 seconds. This will reset all minimum and maximum data recorded to
the current displayed values.
7