Important Information; Connecting The Weather Station And Sensor - THINK GIZMOS TG504 Manual Del Usuario

2. IMPORTANT INFORMATION

2.1 Important Information
In order to get the full screen brightness and easy visability of all numbers and symbols, we
recommend you use the included mains adaptor rather than batteries for the main unit.
The remote sensor will work better if the main unit is powered by the included mains
adaptor rather than batteries.
Regarding the wireless remote sensor (which can be positioned indoors or
outdoors), if it is used outside particulatly in cold conditions we reccomend the use of
Lithium AAA (requires 2) batteries as this will result in a more powerful signal and ensure
no signal loss. This is only precautionary advice and the remote sensor does work fine with
normal Alkaline batteries.
If the main unit does not connect with the remote sensor, press and hold the CH button for
2 secons and it will rescan in order to find the remote sensor.
The weather station needs to be powered for 12 hours before an accurate predition will
display.

2.2 Connecting the Weather Station and Sensor

Weather Station:
Open the battery compartment on the rear side of the weather station and insert the
●
batteries, taking care to observe the correct polarity. Close the battery compartment.
When you insert the batteries, all the symbols on the display will briefly ligh up and you
●
will hear a signal tone.
Wireless Sensor:
● Insert the 2 batteries in to the transmitter, pay attention to observe the correct polarity.
One sensor is supplied with your weather station and is set by default to channel 1.
Press and hold down the 'CH' button for 2 seconds to search for the outside sensor (this
●
will erase the current temperature data inside the clock).
4