C- Installation Of Your Cooler; Selecting The Place Of Installation - Ugur USS 60 DTKL Guia Del Usuario

C -INSTALLATION OF YOUR COOLER.

Selecting the place of installation

The operating environment of the product is very important for the smooth operation of your product. While selecting
the operating environment,
• Do not place your product exposed to outdoor environment (on the street, avenue etc.)
• Be careful for not obstructing lower shutter of the product with materials such as cardboard, box etc. for a proper
cooling. (Picture 4)
• Place the product at least one (1) meter away from heat resources (ex: stove, radiator, electric heater etc.) (Picture 5)
• Do not place it opposite of the air conditioner chutes, under fans and direct door and window openings. (Picture 6)
• Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to the cooler's glass. That means an
increase in the energy consumption.
• Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your pro-
duct.
• While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and
back of your cooler.
WARNING!
In very humid environments, ensure that floor and wall of the place where the cooler is located, is not affected by water;
against discharge water overflow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer on the suitab-
le place for installation and make suggestion, but the consumer shall give the final decision on where the installation will
be made. This process shall also be stated on the relevant installation form by Authorized Uğur Service. In case of any loss
arising from the place of installation of the product according to the final decision given by the consumer, all responsibi-
EN
lity related to such loss shall belong to the consumer.
Your product gives the best cooling performance according to the
climate condition under the conditions given below. Therefore, be
careful that the temperature of the environment where your cooler
will be operated, is at these levels.
Climate Tempera-
Class ture Range
Class 3 16 °C to 25 °C
Class 4 16 °C to 30 °C
Class 5 16 °C to 40 °C
Humidity
Climate Class of your
%60 Rh
product is indicated
%55 Rh
on the technical
specification label on
%45 Rh
the product.
Picture 5
44
Picture 4
Picture 6