Positioning - Ugur USS 60 DTKL Guia Del Usuario

C -INSTALLATION OF YOUR COOLER.

Positioning

Possible placement positions:
1- In a way that the back side alone is opposite to the wall; be careful that there is a gap of 150 mm (15 cm) between
the wall and your cooler. (Picture 7)
2- In a way that is place to a corner; when you place to a corner, leave a gap of 150 mm (15 cm) behind. You can lean the
side corresponding to the corner, to the wall.
The most important point to be considered in all cases of product placement is not to obstruct ventilation of the
compressor assembly.
Without expose your product to any slope, place and operate it in a manner that it is on its feet or wheels. (Picture 8)
The freer the compressor assembly ventilation is, the better the device will run.
EN
Picture 7 Picture 8
45