Working Procedures; Working Principle; Before Use; Removing/Charging/Inserting The Battery Pack - Parkside PAMFW 12 C3 Traducción Del Manual De Instrucciones Original

Working procedures

Working principle

The oscillating drive causes the application tool to
move back and forth at a speed of 5000–19000
times per minute . This allows for precision work
even in confined spaces .
Sawing/cutting
■ Use only undamaged saw blades that are in
perfect working order . Bent, blunt or otherwise
damaged saw blades may break .
■ When sawing lightweight construction mate-
rials, follow the statutory regulations and all
recommendations from the material manufac-
turers .
■ Only soft materials such as wood, plasterboard
or similar should be processed using the plunge
saw process .
Sanding
■ To prolong the service life of the sanding sheets
, ensure that you apply even pressure .

Before use

Removing/charging/inserting the
battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger .
NOTE
► The battery is supplied partially charged .
Ideally, fully charge the battery before use .
You can charge the lithium-ion battery at any
time without shortening its service life . Inter-
rupting the charging process does not
damage the battery .
PAMFW 12 C3
1 . To remove the battery pack
2 . Insert the battery pack
3 . Insert the mains plug into the socket .
4 . The green charge status indicator LED
5 . Insert the battery pack

Checking the battery charge level

♦
from or connect
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C .
release button and pull the battery pack
out of the appliance .
charger .
The control LED lights up red .
indicates that the charging process is complete
and the battery pack
Press the ON/OFF switch
status of the battery (see also main diagram) .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
, press the
into the high-speed
is ready .
into the appliance .
to check the
as follows:
GB │ IE │ 7 ■