Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DE
GB
INTRODUCTION
FR
Use protective work gloves, protective footwear, hard hat and safety
goggles.
NL
ES
Misuse:
-
This product should only be used as described in this
IT
documentation; any other use is considered improper.
-
The manufacturer accepts no responsibility for any
PT
damage caused by the incorrect or unreasonable use of
the equipment.
-
Moreover, misuse shall also void the warranty.
PL
Take care of your tools:
-
Be sure to store your tools in a clean state.
DA
-
Place the tools inside their original package.
-
In order to keep the burnish in good condition, it is
advisable to lubricate the burnished parts with oil.
EL
APPLICATION
– Only specialized personnel are allowed to use the equipment.
– This tool allows the mounting and dismounting of the brake
caliper's fastening screws when working on the braking system.
The arms need not be removed!
– Specific for the front and rear axle of commercial vehicles.
– If screws are very locked, use the wrench and a hammer.
METHOD OF PREPARATION
Utilisation: SW24-12-sides – MB Atego, Actros, SAF
TIGHTENING SUGGESTIONS ACCORDING TO
MANUFACTURER SPECIFICATIONS:
The formula to be used to reach the correct tightening torque is
marked on the wrench.
Marking explained:
Nm1 = desired torque (for example, the manufacturer's
Nm2 = correct value to be applied to the wrench
120 = centre distance from the center of the square section to the
Lw
Example: Nm2 = (Nm1
Count:
1.
2.
3.
specifications).
center of the Torx profile
= distance from the center of the torque wrench handle to the
center of the square of the impact wrench
/ (120
Nm2 = (150Nm / (120mm + 400mm) ) x 400mm
150 x 400 = 60 000
120 + 400 = 520
60 000 : 520 = 115,38 Nm
+ Lw)
) x Lw
5
Tabla de contenido
