Icemaker Installation - GE GTH21 Manual Del Propietário

ICEMAKER INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PARTS INCLUDED
1
NO. DESCRIPTION
1 Water Fill Tube
2 Ice Fill Guide
3 Water Fill Tube Seal
1 INSTALL FILL TUBE
• If the refrigerator already has a
water tube inlet on the back of the
refrigerator, go to Step 2.
• Remove and discard the white plug
from the lower left back corner of
the freezer wall.
• Go to the back of the refrigerator. Find the small
label in the upper right hand corner and peel it
off. Then discard the label.
• Peel one side of the paper away
from the water fill tube seal, slide
the seal along the tube and affix
to the back side of the water
tube inlet flange.
• Remove the adhesive
backing on the opposite side
of the water fill tube seal and
slide the tube into the hole
near the top at the back of the refrigerator. Firmly
press on the inlet to secure it to the refrigerator.
Installation Instructions
Unplug the
Pliers
3
2
QUANTITY
1
1
1
Remove
plug
Seal
REMOVE THE OUTLET COVER
2
• Remove the outlet cover
with a flat-blade screwdriver.
PREPARE FOR INSTALLATION
3
Inside the freezer, loosen the two mounting screws,
but do not screw them all the way out. If your model
does not have the screws already in the freezer wall,
look for two plug buttons. Remove the plug buttons
and insert the two Phillips head screws. The screws
should extend approximately 1/2" (13mm) out
from the freezer wall.
Mounting
screws
4
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
13
Side Back
Hole for
wire tie
(Appearance may vary)