Grinding Disc Replacement / Assembly; Cleaning The Machine; Trouble Shooting; Common Faults - SCANMASKIN SCAN COMBIFLEX 450 Standard Manual Del Usuario

SCAN COMBIFLEX 450/450NS
5.4

Grinding disc replacement / assembly

Follow these steps to replace the Scan-On plate
 Make sure the machine is in its "Safety off position"
 Tilt the machine backwards and secure it.
 Remove any tools used according to"4.14 Changing tools".
 Loosen the three screws holding the Scan-On plate.
 Replace the Scan-On plate.
 It's recommended that new screws are used to fasten the replacement Scan-On plate.
 It's also recommended that copper paste is used on the surface of the screw hole at the Scan-
On plate.
 Tighten all screws by hand and make sure that they are secured.
5.5

Cleaning the machine

Before starting to clean the machine, make sure it is in its"Safety off position"
The power must not be connected while cleaning the machine.
Do not use highly pressurized water to clean the machine.
Water and soap is recommended.
5.6

Trouble shooting

5.6.1 Common faults

Symptom Cause
The machine  There is a power failure from
won't start
The machine only  The motor is overheated
operates while
the start button is
 The control device is dam-
depressed
6
www.scanmaskin.com
the power supply
aged
Correction
 Inspect the fuses in the worksites
fuse box
 Inspect cables
 Measure that all three phases are
present and at full voltage near the
machine
 Wait until the motor is cool again
 Replace the control device
ENGLISH
A
6
O
E
E
O
S
63