Grinding Head Replacement / Assembly; Cleaning The Machine; Trouble Shooting; Common Faults - SCANMASKIN World Serie Manual

SCANMASKIN 32 WORLD SERIES
Every 2000 hours
For more detailed
information about the
2000-hour service
interwall check the
Service Manual
Every 5000 hours
For more detailed
information about the
5000-hour service
interwall check the
Service Manual
5.4

Grinding head replacement / assembly

Follow these steps to replace the grinding head plate
 Make sure the machine is in its "Safety off position"
 Tilt the machine backwards and secure it.
 Remove any tools used.
 Loosen the two screws holding the grinding head.
 Put the plate upside down and loosen the bolts that holds the spring steel discs
 Replace the grinding head or spring steel discs.
 It's recommended that new screws are used to fasten the replacement Grinding head plate.
 Tighten all screws by hand and make sure that they are secured.
5.5

Cleaning the machine

Before starting to clean the machine, make sure it is in its" Safety off position"
The power must not be connected while cleaning the machine.
Do not use highly pressurized water to clean the machine.
Water and soap are recommended.
5.6

Trouble shooting

5.6.1 Common faults

Symptom Cause
The machine won't start  There is a power failure from the power
 The emergency stop button is depressed
 Internal error
5 See access table "Table 52"
www.scanmaskin.com
This service is recommended to be per-
formed by Scanmaskin authorized work-
shop.
 Change the three gearwheels.
(580352+580353)
This service is recommended to be per-
formed by Scanmaskin authorized work-
shop.
 Change all bearings inside the machine house.
 Change the main cog belt
(580338) The maximum expected lifetime for
the belt is 6 years.
supply
Correction
 Inspect the fuses in the worksites fuse box
 Inspect fuses inside electrical cabinet
 Inspect cables
 Measure that all three phases are present and at full
voltage near the machine
 Release the emergency stop button.
 If possible, read the fault code present at the display
inside of the electrical cabinet.
 Contact Scanmaskin Sweden AB
ENGLISH
A
5
O
O
E
E
O
O
97