How To Use The Appliance - babymoov A002030 Instrucciones De Uso

• Electrical and electronic equipment must be disposed of separately.
Do not dispose of electrical and electronic equipment with general
household waste and use a separate collection system.
a. Measuring device
b. Warming tank
c. Jar basket
Instructions to use appliance correctly:
- always make sure the baby bottle is slightly open.
- always remove the jar's lid.
- to ensure the contents are warmed up properly, do not interrupt the process.
- only use tap water without any additives.
PLEASE NOTE: always use the adapter ring and the basket to warm up baby bottles and jars.
By putting in the amount of water specified in the tables below, the bottle or jar will be warmed up to 30°/33°.
The doses are meant as a guide. If you believe that the water is too warm or not warm enough for your baby, reduce or increase the
amount of water.
Caution: these amounts of water are meant for a polycarbonate bottle without a removable bottom.
Using the appliance at home
Put the bottle-warmer on a flat and steady
surface. Make sure the bottle-warmer's power
cable is out of the reach of children.
Plug the power cable into a power outlet.
1-2. Fill up the measuring device (a) with
water by following the doses reported
here to the side and then pour the water
into the warming tank (b).
3. Put the baby bottle in the bottle-warmer's
warming tank (b).
4. If using a standard/small baby bottle, place
the adapter ring (d) around the bottle to
better warm up the contents.
5. To warm up a jar, place it in the designated
basket (c) and then in the warming tank (b).
6. Press the ON button (e) to start the heating
cycle. The backlit ring (h) will turn red,
which means that the heating cycle is in
progress.
CAUTION! The steam that comes out
during the heating cycle is very hot. Do not
put your hands on the appliance when it is
in use.
7. The bottle-warmer turns off automatically
when the heating cycle is over. At the same
time, the backlight ring (h) will turn green for a minute, which means that the bottle is ready.
Take out the bottle or jar straight away with a pair of tongs or a cloth as they are hot.
8

HOW TO USE THE APPLIANCE

d. Adapter ring
e. ON button
f. Cigarette-lighter adapter
TULIPE HOME/CAR BOTTLE-WARMER • Instructions for use
• This EU symbol indicates that this product must not
be disposed of in a dustbin or mixed with household
waste, but must go in a separate collection system.
Amount of water to put
Amount of milk in the measuring device
in the bottle
60 ml
90 ml
120 ml
150 ml
180 ml
210 ml
240 ml
270 ml
300 ml
330 ml
Jar to put into the measuring
120 g
200 g
250 g
g. Power cable
h. Backlit ring
Amount of water to put
in the measuring device
for a bottle with
lukewarm water
7 ml
8 ml
10 ml
11 ml
12 ml
13 ml
14 ml
15 ml
16 ml
17 ml
Amount of water
device for a jar
10 ml
12 ml
15 ml
for a bottle from
the fridge and
prepared beforehand
10 ml
12 ml
12,5 ml
13 ml
13,5 ml
14 ml
14,5 ml
15 ml
15,5 ml
16 ml
Amount of water
to put into
the measuring device
for a jar
from the fridge
18 ml
22 ml
28 ml