TESY MC 2014 Manual Del Usuario página 3

•
Never keep the appliance unnecessarily switched
on. Disconnect it from the power socket when you
do not intend to use it for a long period of time.
•
The appliance should not be positioned right under
a power socket!
•
Warning: Do not use this appliance with a
programming device, counter or any other device
which can automatically switch it on because if the
appliance is covered or improperly positioned this
may cause fire.
•
Position the power cord in such a way that it does
not obstruct the free movement of people and
cannot be stepped on! Use only approved extension
cords which are suitable for this appliance, i.e. have
got a conformity sign!
•
Never move the appliance by pulling its power cord
and do not use the power cord for carrying objects!
•
Do not bend the power cord and do not stretch it
over sharp edges, do not position it over hot plates
or open flames!
•
Never use this appliance in close proximity to
wet premises – bathroom, a shower cabin or a
swimming pool!
PACKING
•
After unpacking the appliance, check if all its
elements are included in the packing and that it has
not been damaged during transportation! In case
damage or incomplete delivery is found, contact
your authorized retailer!
•
Do not throw away the original packing! It could
be used for storage and transportation purposes in
order to avoid damages during transportation!
•
Disposal of packing materials should be done in
the appropriate way! Children should be prevented
from playing with polyethylene bags!
INSTALLATION
Before connecting your panel heater:
Turn the panel heater upside down in order to
1.
mount the castor wheels.
Press the first set of castor wheels towards the holes
2.
then put the screws into the holes and tighten them
with a screw-driver.
Repeat the operation for the second set of castor
3.
wheels.
English
Put the panel heater into its correct upright position.
4.
The panel heater must be positioned at a safe distance
5.
of minimum 1 meter away from any wall or object.
OPERATION OF THE APPLIANCE
Remote control
Connect the power cord after ensuring that voltage
1.
supplied to your home corresponds to the values on
the appliance technical plate.
In order to provide power supply to the panel
2.
heater, turn the power button to position I – the
display will flash for a while.
You can use the touch panel or the remote control
3.
to adjust the panel heater
Push button , to turn on the appliance. The panel
4.
heater will operate at its maximum power (2000W)
and the display will show the value of the room
temperature
Using the buttons
5.
whether the panel heater to operate at half of its
power (1000W) or at its full power (2000W). That is
indicated by lights at the right corner of the display
•
One light on – half power 1000W.
•
Two lights on – full power 2000W
Setting the timer
6.
•
Push button - the display will show indication
0:00
•
Using the buttons
number of hours from 0 to 18 (the available options
are at 30-minute intervals) in order to adjust when
the panel heater to start and to stop its operation
LED Display
Temperature increase/
decrease and time
adjustment button
Temperature
adjustment button
Timer button switching
on/off
ON/OFF button
and , you can select
and , one can set the
Usage and Storage Instructions
EN
3