Overload Cutout; Storing The Machine; Maintaining The Mowing Head - Stihl FSE 60 Manual De Instrucciones

English

Overload Cutout

STIHL FSE 71 and FSE 81 electric
trimmers are equipped with an overload
cutout.
The overload cut out cuts off the power
supply in case of mechanical or thermal
overload.
If the overload cutout has cut off the
power supply:
Wait about 3 minutes before
N
switching on again.
Do not switch on the unit during this
period because you will otherwise
prolong the required cooling time.
Once the motor starts:
Run the unit for about 15 seconds
N
off load. This helps cool the motor
windings and considerably delays
renewed tripping of the overload
cutout.
42

Storing the Machine

For periods of 3 months or longer
Thoroughly clean the machine,
N
especially the cooling air inlets.
Take out the spool with nylon lines
N
and engage the ends of the lines in
the spool's notches. Clean and
inspect the spool.
The resilience and service life of the
nylon line can be increased by storing it
in a container filled with water.
Store the machine in a dry, high or N
locked location, out of the reach of
children and other unauthorized
persons.
Maintaining the Mowing
Head
Placing Power Tool on the Ground
Switch off the power tool.
N
Lay your trimmer on its back with
N
the loop handle facing down and the
output shaft facing up.
FSE 60, FSE 71, FSE 81