Adsl Configuration - Juniper Networks NetScreen-5GT Wireless Manual Del Usuario

ADSL C
ONFIGURATION
This section describes the default settings and operation of the NetScreen-5GT Wireless
ADSL Annex A and B devices as they are shipped from the factory. These default settings
are such that, in most cases, there are only a few items that you must configure.
This section describes the following configurations for the Untrust zone interface:
• Configuring the ADSL Interface
• Adding Virtual Circuits to an ADSL Interface
• VPI/VCI and Multiplexing Method
• PPPoE or PPPoA
• Annex B Mode
• Static IP Address and Netmask
Note: If at any point you need to restore the device to its default settings, see
Device to Factory Defaults" on page
The figure below shows the default configuration for the NetScreen-5GT Wireless ADSL
device.
Telephone
Outlet
ADSL Interface
(adsl1)
NetScreen-5GT Wireless
29.
To Internet
wireless1 interface
wireless2 Interface
192.168.2.1/24
Trust Interface
192.168.1.1/24
Hub
Trust Zone

ADSL Configuration

"Resetting the
Wzone1
19